Hello
I have Becker blinds with motors like "Becker Rohrmotor Funk P9-C01 - P9/16C PROF+ - 9 NM". (https://www.caliso.de/becker/rohrmotor- ... -9-nm-4897)
These are radio engines
The communication is at a frequency of 868 MHz
So...
I wanted to buy RFLink 868.3 OOK Gateway componenten (https://www.nodo-shop.nl/nl/rflink-gate ... enten.html) but I do not know if it will work with my motors.
On page : http://www.rflink.nl/blog2/devlist not found any backer motors .
I want everything connect to my Domoticz system.
Can anything help me in this matter ?
Becker motors
Moderators: rtenklooster, Voyager, BertB, Stuntteam
Re: Becker motors
Hi,
I have a remote from Becker (Centronic EasyControl EC545) to operate my blinds.
I am also eager to know if the RFLink is working with the remote/receivers?
Thank you in advance!
I have a remote from Becker (Centronic EasyControl EC545) to operate my blinds.
I am also eager to know if the RFLink is working with the remote/receivers?
Thank you in advance!
-
- New user
- Posts: 2
- Joined: 09 May 2018, 13:09
Re: Becker motors
Hello
I have TC4410-II for my blinds.
I bought rf-link 868 from https://www.nodo-shop.nl/en/rflink-gate ... nents.html with antenna.
I'm trying to do anything. For now in serial port i have many information, but I do not understand them very much ;(
I have TC4410-II for my blinds.
I bought rf-link 868 from https://www.nodo-shop.nl/en/rflink-gate ... nents.html with antenna.
I'm trying to do anything. For now in serial port i have many information, but I do not understand them very much ;(
Re: Becker motors
Hello, I too would like to build an 868MHz RFLink to use Domoticz to control Becker motors.
Can anybody help with how one can go about developing this?
Can anybody help with how one can go about developing this?
Who is online
Users browsing this forum: No registered users and 38 guests