Somfy Centralis Uno RTS

Post here about devices that are not yet or not fully supported

Moderators: rtenklooster, Voyager, BertB, Stuntteam

Post Reply
Message
Author
cellentano
New user
Posts: 2
Joined: 14 Apr 2019, 17:42

Somfy Centralis Uno RTS

#1 Post by cellentano » 14 Apr 2019, 18:19

Hi,
I built my RFLink controller based on arduino - Robotdyn Mega 2560 PRO with RFLink v39-49 firmware. Tried Superheterodyne 3400 & Aurel Tranceiver (Somfy RTS) too. My point is to control Somfy RTS Blinds with Somfy Centralis Uno RTS receiver. Pairing of the controller was not an issue, but finally, it is more-less not possible correctly control blinds:
1. TX pulse is too short - blinds move just 10-15 cm (3-5 sec.)
2. If RTSLONGTX=ON, TX pulse is too long - blinds cant be stopped at the required position or to tilt them - giving timeout in acknowledge.
3. MY(STOP) command doesnt work for predefined (stored) position (command STOP sent in fully open/closed position)
All those issues present in control with RFLink loader or in Home Assistant (Rapsberry Pi).

I couldn't find anything helpful on internet to solve this issues. It looks like RFLink firmware incompatibility.

Voyager
Normal user
Posts: 59
Joined: 15 Apr 2015, 14:25

Re: Somfy Centralis Uno RTS

#2 Post by Voyager » 14 Apr 2019, 23:40

http://www.rflink.nl/blog2/devlist
Centralis Uno is not listed and thus might not work..
In that case you need to check:
http://www.rflink.nl/blog2/development

cellentano
New user
Posts: 2
Joined: 14 Apr 2019, 17:42

Re: Somfy Centralis Uno RTS

#3 Post by cellentano » 15 Apr 2019, 10:05

Yes, I know.
But my remotes are Somfy Telis RTS, which is listed. Therefore I supposed it should work.

Post Reply

Who is online

Users browsing this forum: No registered users and 16 guests