Rflink cant see 433.92 jablotron sensor

Post here about devices that are not yet or not fully supported

Moderators: rtenklooster, BertB, Voyager, Stuntteam

Post Reply
Message
Author
martc
Normal user
Posts: 4
Joined: 29 Sep 2019, 00:37

Rflink cant see 433.92 jablotron sensor

#1 Post by martc » 30 Sep 2019, 13:49

I have rflink r48, all work fine with aurel 433.92 rtx, reading temp/hum sensors, turning on/off switches. I get jablotron pir and door sensors 433.92 (JA-60N, JA-60B, JA-60P) and rflink cant see this sensors. Turning on debug mode doesnt help. With SDR RTL v3 in Sdrsharp i see 4 very short packets transmission from jablotron on 433.90Mhz. Rflink not detect this. Rflink see my car remote in debug mode, but cant see jablotron sensors.. maybe rflink firmware ignore this very short packet? jablotron sensors have on transmitter 433.92 rezonatir, and on label is info 433.92 too.

martc
Normal user
Posts: 4
Joined: 29 Sep 2019, 00:37

Re: Rflink cant see 433.92 jablotron sensor

#2 Post by martc » 06 Oct 2019, 17:22

I check output of receiver 433.92Mhz with logic analyzer, and i see four short packet, every time when i triger sensor... rflink in debug mode see nothing. I try with another mega 2560 with rflink firmware and receiver rxb6 433.92, the same situation. Logic analyzer on receiver output see packet, rflink in debug mode not....

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests