Page 1 of 1

Rflink cant see 433.92 jablotron sensor

Posted: 30 Sep 2019, 13:49
by martc
I have rflink r48, all work fine with aurel 433.92 rtx, reading temp/hum sensors, turning on/off switches. I get jablotron pir and door sensors 433.92 (JA-60N, JA-60B, JA-60P) and rflink cant see this sensors. Turning on debug mode doesnt help. With SDR RTL v3 in Sdrsharp i see 4 very short packets transmission from jablotron on 433.90Mhz. Rflink not detect this. Rflink see my car remote in debug mode, but cant see jablotron sensors.. maybe rflink firmware ignore this very short packet? jablotron sensors have on transmitter 433.92 rezonatir, and on label is info 433.92 too.

Re: Rflink cant see 433.92 jablotron sensor

Posted: 06 Oct 2019, 17:22
by martc
I check output of receiver 433.92Mhz with logic analyzer, and i see four short packet, every time when i triger sensor... rflink in debug mode see nothing. I try with another mega 2560 with rflink firmware and receiver rxb6 433.92, the same situation. Logic analyzer on receiver output see packet, rflink in debug mode not....