Let's Control It

Hi,

Is it possible to control the Ikea ANSLUTA with RFLink?

Thanks!

Hi,

Make a log of the remote control signal as described here:
http://www.nemcon.nl/blog2/2015/07/cc

and we will add support for it.
Protocol details are known so ti should not take long.

I think it is not supporterd. What do you think?

http://www.ikea.com/nl/nl/catalog/products/90300773/

Anyway, thanks for your help!

That is the 2.4Ghz version. It is not supported.
There is also a 433mhz version..

I've read that Ikea doesn't make those anymore. They only have 2.4Ghz version. So I have bad luck.

Thanks anyway!

Should be a nice extra....
RFlink support 2.4Ghz...
Is this perhaps possible?

Perhaps yes.. did anyone open one yet..?
I might pick one up when I am close to a store.

is there perhaps a option that this going to work...
Is the hardware that is needed on the RFlink?

I buy one [ when i am @ Ikea ] or i will support one to a developer [ paypal ] to try it.

I picked one up at ikea..
CC2500 RF chip is used.
It will take time to analyze the signal and see if it can be implemented.

Stuntteam wrote:I picked one up at ikea..
CC2500 RF chip is used.
It will take time to analyze the signal and see if it can be implemented.

Price?
What paypal?

Support for the 2.4Ghz Ansluta has now been integrated in RFLink

Stuntteam wrote:Support for the 2.4Ghz Ansluta has now been integrated in RFLink

Ansulta works also with NRF24L01 ??

We need a CC2500??

Regards!

Ansluta is not working with the NRF24L01.. it only works with the CC2500

Hi

Thanks for your quick answer....

Its a good new!! I'm going to order a CC2500!


Regards!