Let's Control It

Hello everyone,

Some months ago, I bought a complete rflink from nodo shop, and I recently decided to automate a bit my doorbell, I first had a look to the supported devices list and I found a supported doorbell button a Byron BY37.

Sadly it seems, the rflink didn't receive the information all the time, I'm using the dipole antenna from nodo shop, and I have plenty of other devices connected to the rflink without any issue.

But it seems the information comming from this button is not always properly decoded, as even if i'm close to the rflink antenna when pusshing the buton nothing happen.

Do you have nay idea how I can improve this ?

Thank you in advance.

Make a debug log as explained here:
http://www.rflink.nl/blog2/development
and mail the results to frankzirrone@gmail.com

I will then check what is going on..

Thank you for your answer Stuntteam,

I will do it this evening when I will come back home.

Best regards,

Got it working! Thanks for the link.

Also looking for BY support ... did anyone get anywhere with this?