I've try to build my own RFLink but I'm facing issues with transmission.
Just to sumarise
I've uploaded the latest firmware in the arduino and realise the wiring (Mega 2560 + RXB6 + FS1000A). I launch RFLinkLoader.exe and start serial port logging.
Code: Select all
20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R48;
10;version;
20;01;VER=1.1;REV=48;BUILD=04;
10;status;
20;02;STATUS;setRF433=ON;setNodoNRF=OFF;setMilight=OFF;setLivingColors=OFF;setAnsluta=OFF;setGPIO=OFF;setBLE=OFF;setMysensors=OFF;
Code: Select all
20;03;NewKaku;ID=0136e71e;SWITCH=1;CMD=ON;
My first idea was that the FS1000A doesn't work correctly. But when I connect it directly (oalon without arduino) on 5V power supply (VCC+DATA to 5V ; GND to GND). I can measure on spectral analyser the fundamental 433 > So it works fine
My 2nde idea was that arduiono does not send the VCC (RX3) and data (TX3) to FS1000A. So I've connected an oscilloscope to RX3 or TX3 and there is nothing. (Trigger detection on the scope). I've disconnect FS1000A to be sure that there is no short circuit that will create issue. but it's the same.
So my first conclusion is that my arduino has an issue. But I'm technician and my lastest test was to generate a short arduino programme to test RX3 and TX3 pins (without the radio mudule) with a LED and resistor.
Code: Select all
void setup(){
pinMode(15,OUTPUT);
}
void loop(){
digitalWrite(15,HIGH);
delay(1000);
digitalWrite(15,LOW);
delay(1000);
}
So I'm lost, with all my tests i can only conclude that there is an issue with the code and my arduino because it looks like working properly with all the others
If we have an idea, it will be great news
Thanks