Hi,
I just bought a windows shutter from Brel with the Brel DD2702 remote.
I tried receiving the signal from the remote through RF-link, but I am not receiving anything. With debug and/or unhandled on it still receives nothing. According to the datasheet it operates at 433.925 mhz. What am I doing wrong or what am I missing here?
Datasheet:
https://cdn.bluenotion.nl/68cfe8a875f9a ... D-2702.pdf
RFLink receives no signal from Brel Remote
Moderators: rtenklooster, Voyager, BertB, Stuntteam
-
- New user
- Posts: 7
- Joined: 24 Oct 2017, 20:27
Re: RFLink receives no signal from Brel Remote
That remote appears to support bi-directional as well as uni-direction communication modes.
Try switching to uni-directional mode.
Try switching to uni-directional mode.
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
-
- New user
- Posts: 7
- Joined: 24 Oct 2017, 20:27
Re: RFLink receives no signal from Brel Remote
When I switch the remote to mono-direction, RF-link detects the signal. However I seem unable to pair the remote with my motor when it's set to mono-direction. The type of motor from Brel is called a bi-directional motor according to the manual. I am unable to locate the exact type/serial of the motor .
-
- New user
- Posts: 7
- Joined: 24 Oct 2017, 20:27
Re: RFLink receives no signal from Brel Remote
Just got confirmation from the manufacturer. It's not possible to connect a mono-direction remote with a bi-directional motor.
Well I think I need to solder an ESP32 on top of my remote if I want to be able to control the blinds with my domotica system.
Well I think I need to solder an ESP32 on top of my remote if I want to be able to control the blinds with my domotica system.
Who is online
Users browsing this forum: No registered users and 17 guests