It is up and running. Nice.
I try to do the following.
My alarm system switches from 12v to GND if set, and to 0v unset. Well that is interesting.
I want to capture this signal (voltage) and send it with a espeasy switch to my domoticz.
The 12v has to go down to 3v (buckconverter) to not blow up a GPIO input port.
So i started testing.
Created a switch device on GPIO2. Configured Domoticz Details , Virtual Switch On/Off etc etc
When connecting 3v to the GPIO2 pin it says SW: State 1 (Domoticz shows me alarm on), when disconnecting or connect to ground it say SW: State 0. (Domoticz sasys Alarm Off)
Well job done right ??
However... when I try to access the 'devices' tab of the ESP01 webinterface...
it reboots... All other tabs work just fine for configuration. Only when clicking devices it reboots.
Exception (0).
- ESP-Reboots.JPG (63.71 KiB) Viewed 1857 times