Private project [HÖRMANN REMOTE CONTROLLED GARAGE PORT CONTROLLED WITH ESP8266]

[danmero]

My unit did not have a connection for a simple NO. Only a flat cable to the membrane switch panel.

Can you post the model of your door control.

Regarding open close status. Another esp is doing that. It has a limit switch for the close status. And a rotary encoder for position if open.

I use the same NodeMCU, 2 NO contacts for Open/Close, one Dummy to hold the last state Open/Close and rules/timers to trigger the action.
- If both open and dummy value 1 , action closing.
- If both open and dummy value 0, action opening.
- If door close , dummy value 0, strobe off
- if door open , dummy value 1

For dual garage door, 2 controllers I use one NodeMcu, 4 door contacts, 2 LED strobe.

Regards,

[grovkillen]

My model is SupraMatic E2

[danmero]

SupraMatic E2 page 34 img 11 (best I can find) or from factory SupraMatic E3 page 24 img 12

Regards,

[grovkillen]

Those terminals are not on my unit. I guess it's a cheap one?

[danmero]

Do you have the original battery backup package?

[grovkillen]

No not that I've seen.

[danmero]

Take a look at this link

Regards,

[grovkillen]

No I don't have that one.