Help switching time too short
Posted: 05 Jan 2019, 11:37
Hello World,
I use an ESP-01 with mega-20181220.
I have two switch between GND and GPIOs directly connected without other component resistor or capacitor
One Doorbell between GND and GPIO 0
One Door Contact between GND and GPIO 2
The Door Contact don't work every time, in case of the door is too quickly opened. I don't receive anything with MQTT.
Is it possible to correct this by computer code ?
Or do I have to correct this electronically ?
Thanks in advance
Olivier
I use an ESP-01 with mega-20181220.
I have two switch between GND and GPIOs directly connected without other component resistor or capacitor
One Doorbell between GND and GPIO 0
One Door Contact between GND and GPIO 2
The Door Contact don't work every time, in case of the door is too quickly opened. I don't receive anything with MQTT.
Is it possible to correct this by computer code ?
Or do I have to correct this electronically ?
Thanks in advance
Olivier