cobrp wrote:I'am trying to install ESPEasy on a ESP8266-01, it's black. I want to use ESPEasy with Domoticz.
Flashing a nodeMCU with esptool.py works well.
I did try to flash the 1024 k and 512 k binary images both from R78.
Both images flash well with or without the parameter set: -fs 32m -fm dio -ff 40m at the end of the command line.
But when I open a terminal after a reset
-fs 32m means that you try to write to a 4 MB (32 Mbit) flash. You should either use -fs 8m and the 1MB file, or no -fs option (default is 512k flash) and the 512k image. Since you probably want to do OTA upgrades in the future, I suggest you use the 1M option
-fs 32m only applies to modules with 4 MB flash (ESP-12)
You can write a smaller image to a 4 MB flash, but you need to set -fs accordingly
Make sure your version of esptool supports the -fs option - it was not present in older versions
- Jan