SonOff T3

Moderators: grovkillen, Stuntteam, TD-er

Post Reply
Message
Author
Cdzn
Normal user
Posts: 58
Joined: 06 Oct 2020, 18:15

SonOff T3

#1 Post by Cdzn » 03 Nov 2021, 22:06

I decided to flash my SonOff T3EU2C and flashing it ESP8266.normal 1m. To configure it i should set touch button on GPIO-9 and write the rules switch GPIO-5 whenbutton is acctive. But i can`t see GPIO-9. Here is a screenshot.
Image
Attachments
123.jpg
123.jpg (312.87 KiB) Viewed 8403 times
Last edited by Cdzn on 03 Nov 2021, 22:25, edited 1 time in total.

TD-er
Core team member
Posts: 8643
Joined: 01 Sep 2017, 22:13
Location: the Netherlands
Contact:

Re: SonOff T3

#2 Post by TD-er » 03 Nov 2021, 22:17

GPIO-9 is not available in an ESP8266. For that you need an ESP8285.
So please check if the unit really has an ESP8285 and then use that build for it.

Cdzn
Normal user
Posts: 58
Joined: 06 Oct 2020, 18:15

Re: SonOff T3

#3 Post by Cdzn » 03 Nov 2021, 22:26

TD-er wrote: 03 Nov 2021, 22:17 GPIO-9 is not available in an ESP8266. For that you need an ESP8285.
So please check if the unit really has an ESP8285 and then use that build for it.
Ok. Will try tomorrow. Thanks for advice

Cdzn
Normal user
Posts: 58
Joined: 06 Oct 2020, 18:15

Re: SonOff T3

#4 Post by Cdzn » 04 Nov 2021, 06:08

TD-er wrote: 03 Nov 2021, 22:17 GPIO-9 is not available in an ESP8266. For that you need an ESP8285.
So please check if the unit really has an ESP8285 and then use that build for it.
Yep. This is 8285.
photo_2021-11-04_12-06-18.jpg
photo_2021-11-04_12-06-18.jpg (77.5 KiB) Viewed 8387 times
Thank You! Mb for someone it could be helpful.

Post Reply

Who is online

Users browsing this forum: No registered users and 11 guests