esp adaptor board?

Moderators: BertB, Voyager, grovkillen, Stuntteam, LisaM

Post Reply
Message
Author
User avatar
uxhamby
Normal user
Posts: 30
Joined: 29 Dec 2016, 18:13
Location: Toronto Canada

esp adaptor board?

#1 Post by uxhamby » 09 Dec 2018, 21:04

Image

On this style of esp adaptor board, am I safe to assume that the 3 resistors are gpio pull ups / downs for proper boot state?

I can't find a schematic of these boards anywhere, can anyone point me to one?

Thanks,

Brian H.

Drum
Normal user
Posts: 265
Joined: 07 Feb 2016, 11:56

Re: esp adaptor board?

#2 Post by Drum » 10 Dec 2018, 09:29

I am not aware if any official schematics and have seen several different versions of these, the ones I purchased have pads for an 1117 type voltage regulator which I would never use. You can see the traces under the white paint pretty easily, make your own schematic and be sure it is correct for the version of the board you have. You can also use a ohm meter to check.

User avatar
budman1758
Normal user
Posts: 223
Joined: 15 Apr 2017, 05:13
Location: Riverside CA USA

Re: esp adaptor board?

#3 Post by budman1758 » 14 Dec 2018, 05:37

I have some of those boards.
R1 pulls GPIO2 up
R3 pulls CH-PD up
R2 is connected to the pad on the back and is unused unless you install a voltage regulator there.
"The glass is twice as big as it needs to be".

LisaM
Normal user
Posts: 511
Joined: 11 Apr 2017, 18:29

Re: esp adaptor board?

#4 Post by LisaM » 06 Jan 2019, 20:10

ESP32 boot states and GPIO pins are perfectly described here: https://github.com/espressif/esptool/wi ... -Selection

Cheers,

Lisa

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest