Functionality status

Moderators: Voyager, BertB, Stuntteam, LisaM

Post Reply
Message
Author
LisaM
Normal user
Posts: 510
Joined: 11 Apr 2017, 18:29

Functionality status

#1 Post by LisaM » 24 Dec 2017, 14:08

WORKING functionality:

Main page:
  • System info
Config page:
  • Unit name
  • Unit number
  • Webserver port
  • Admin Password
Controllers page:
  • Everything
Hardware page:
  • I2C
  • SPI
  • UART
Devices page:
  • Everything
Scripts page:
  • Everything
Rules page:
  • Everything
Notifications page:

Tools page:
  • System
  • Wifi Scan
  • i2C Scan
  • Settings
  • Filesystem
Advanced page:
  • NTP settings
  • Log Settings

Standard Sensors:
  • Switch (GPIO)
  • DS18B20 (OneWire)
  • BME280 (I2C)
List of functionality NOT working as of this version:
Main page:
  • Node list
Config page:
  • Sleep enabled
  • Sleep Delay
  • Sleep on connection failure
Hardware page:
  • Boardled
  • Inverseled
  • Boot states
Notifications page:
  • Notifications are not functional at the moment
Tools page:
  • Firmware
Advanced page:
  • Controller settings
  • Serial Settings
  • Inter ESPEasy network
  • Special and experimental

DeNB3rt
Normal user
Posts: 119
Joined: 15 Dec 2015, 14:07

Re: Functionality status

#2 Post by DeNB3rt » 07 May 2018, 16:47

awesome :)


Last bumped by LisaM on 07 May 2018, 16:47.
Located in Belgium, Bruges. Working on a full DIY domoticz setup with ESPEasy.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest