hi,
i am deploying three new wemos with r103.
if i open a serial monitor _before_ i flash the firmware, the erase-process is running longer after the flash-complete message.
if i dont have the serial monitor beforehand, i dont see the erase process --
and would have made the requestet cold boot immediately after the complete message
(and i suggest this causing me some errors in the past).
do i have to wait for the end of the erase process?
do the devs have to take action here? does the wiki needs some information about this?
flashing with arduino dont show erase. Wiki notice nedded?
Moderators: grovkillen, Stuntteam, TD-er
flashing with arduino dont show erase. Wiki notice nedded?
- Attachments
-
- Zwischenablage03-3.png (96.17 KiB) Viewed 3367 times
Who is online
Users browsing this forum: No registered users and 13 guests