ESP-12E/F LED Status.

[Minims]

Hello everybody,

I use some 2 ESP-12E node mcu and 2 ESP-12F (minimal version) with ESPEASY. All is fine with this, it'a very good project .

My problem is located on the Blue LED solder on the ESP-12. I can't find a solution to disable totally this LED. I don't want to scratch it, just disable via software.
Blue LED is always ON. I've not this problem if I used a small sketch on the same ESP. I suppose I missed something in the ESPEASY config.

Does anyone has a solution for this. ?

Thx.

[paxi]

According to this page
http://www.esp8266.com/wiki/doku.php?id ... esp-12-e_q
the LED is on gpio 2, active low.

[Minims]

I've made an erase flash with esptool and upload espeasy again, the led is no more active by default. Quite strange ...
I will try on a second ESP.