Hello everybody,
I use some 2 ESP-12E node mcu and 2 ESP-12F (minimal version) with ESPEASY. All is fine with this, it'a very good project .
My problem is located on the Blue LED solder on the ESP-12. I can't find a solution to disable totally this LED. I don't want to scratch it, just disable via software.
Blue LED is always ON. I've not this problem if I used a small sketch on the same ESP. I suppose I missed something in the ESPEASY config.
Does anyone has a solution for this. ?
Thx.
ESP-12E/F LED Status.
Moderators: grovkillen, Stuntteam, TD-er
Re: ESP-12E/F LED Status.
According to this page
http://www.esp8266.com/wiki/doku.php?id ... esp-12-e_q
the LED is on gpio 2, active low.
http://www.esp8266.com/wiki/doku.php?id ... esp-12-e_q
the LED is on gpio 2, active low.
Re: ESP-12E/F LED Status.
I've made an erase flash with esptool and upload espeasy again, the led is no more active by default. Quite strange ...
I will try on a second ESP.
I will try on a second ESP.
Who is online
Users browsing this forum: Bing [Bot] and 61 guests