Question about Status

Message

hans65 · #1 Post by **hans65** » 04 Apr 2018, 10:53

In the log file I see the status of my switch device changes ever second, is this normal?

grovkillen · #2 Post by **grovkillen** » 04 Apr 2018, 11:56

No not normal. Can you measure the GPIO and see if it's not quite high enough voltage wise making it jump like that?

hans65 · #3 Post by **hans65** » 04 Apr 2018, 15:10

Sorry but I don't have necessary tools to measure GPIO. I think with the previous firmware I did not have had this problem.
Currently I'm on 20180306

AndrewJ · #4 Post by **AndrewJ** » 04 Apr 2018, 16:41

I'm not certain, but the use of "Switch" for both the task and the value may be causing problems.
You could try changing them to see if it helps.

hans65 · #5 Post by **hans65** » 04 Apr 2018, 17:18

AndrewJ you are a genius, it works thanks

AndrewJ · #6 Post by **AndrewJ** » 04 Apr 2018, 21:20

Glad to be of help!

grovkillen · #7 Post by **grovkillen** » 04 Apr 2018, 22:20

Good spotted!