Hi,
I made a cat door using a servo to pull up/release a shutter.
On the top and on the bottom there are magnetic door sensors to stop the pull up/release action.
Everything runs on EasyESP 2.0 - dev 11 on works fine. The switch detecs and sends the stop command to the servo.
But when I want to read the switch again after stopping the servo the value becomes 0.
Whats wrong?
Best regads,
Gert
The rules:
On Beneden#Switch do
if [Beneden#Switch]=1
servo,2,12,90
endif
endon
On Boven#Switch do
if [Boven#Switch]=1
servo,2,12,80
endif
endon
ESPEasy Servo and reset GPIO
Moderators: grovkillen, Stuntteam, TD-er
Re: ESPEasy Servo and reset GPIO
Do you have an unused and disabled "Domoticz HTTP" controller in the list of controllers?
Then please remove that one.
Then please remove that one.
Who is online
Users browsing this forum: No registered users and 93 guests