Still a little help needed / HTTP send command
i am still a little fighting on my side here.
Could someone give this a try with a newer version like 201809xx :
Code: Select all
on System#Boot do Monitor GPIO,0 Monitor GPIO,4 Monitor GPIO,5 Monitor GPIO,16 timerSet,1,30 endon on GPIO#16=1 do SendToHTTP 192.168.123.10,8080,/json.htm?type=command¶m=switchlight&idx=17&switchcmd=On endon on GPIO#16=0 do SendToHTTP 192.168.123.10,8080,/json.htm?type=command¶m=switchlight&idx=17&switchcmd=Off endon
With 20180826 i get "GET /json.htm?type=command¶m=switchlight&idx=17&switchcmd=Off" wich i can work with and all is fine.
After posting all my trouble in here, TD-er gave me a hint my receiver script for php is not a very good code.
So a friend and mine designed the receiver script new from scratch. Then i tryed newer images as 20180826 and i dont even get a message from ESP-Easy.
So now i am not sure it is only the falt of my receiver scripts.
I do not get any raw HTTP messages with higher the 20180826.
No controller user and no password is in use.
Can this maybe the problem ?
Hardware is nodemcu lolin V3
Thank you for your help!