does it make a difference to monitor a gpio pin instead and run a task, based on that change.
eg, is there a difference in responsetime, cpu overhead
i know when i want to monitor a gpio pin i need to add a monitor command at startup and i can imagine this takes extra cpu cycles
Also i can imagine that the GPIO status is totally unfiltered so jitter can occur were as using the plugin might avoid things
thanks
so in my case
Code: Select all
On Watermeter#Count do
if [Watermeter#Count] > 0 and [Watermeter#Time] > 2500
Code: Select all
On GPIO#14=0 do
if [Watermeter#Time] > 2500