Serial MCU controlled switch?

[uxhamby]

I have a couple of ESP01 8266's that run a custom version of the EE firmware, to accommodate a relay board via a 'DEVICE' listed as "Serial MCU controlled switch". The issue was a non standard relay board from EBAY.

Build 20102 - Mega (ESP82xx Core 2_4_1, NONOS SDK 2.2.1(cfd48f3))
GIT version xuryV0.1

I still see these boards listed on EBAY but I don't see the device listed in the 'DEVICE' offerings of current versions of EE I have running.

What's the current story on this?

Thanks,

Brian H.

[TD-er]

Is it the same as supported in P091 ? https://espeasy.readthedocs.io/en/lates ... #p091-page

[uxhamby]

Is it the same as supported in P091 ?

Looks similar but can't say for sure.

[uxhamby]

I believe the relay board in question, is one of these:





Looks like lots of work was done but I don't see a resolution emerge. I'm still left wondering: do any contemporary stock builds support this device out of the box?

Thanks

[enesbcs]

Build 20102 - Mega (ESP82xx Core 2_4_1, NONOS SDK 2.2.1(cfd48f3))
GIT version xuryV0.1

xury just compiled its own version from github sources, i guess it is the same as the old ones with Core 2.4.1:
viewtopic.php?p=42226#p42226

In theory it will also work with the current P091 plugin that is part of TESTING binaries.

The only question is: Are there the serial commands intact on the secondary MCU? Most of them works in the same way, except some bad batch with messed ASCII command codes as i know.