Anyone tried this yet?

[Drum]

I came across this today, looks very interesting...
https://www.olimex.com/Products/IoT/ESP32-WROVER-KIT/

ESP32-WROVER-KIT DEVELOPMENT BOARD FOR ESP32 WITH JTAG AND LCD DISPLAY, CAMERA INTERFACE, SD CARD, RGB LED, IO EXPANDER

This is made by Espressif so may be available from china directly for less.

FEATURES
ESP32-WROVER module with 4MB RAM and ESP32 silicone rev.1
3.2" LCD display
MicroSD card connector
Micro USB connector
Built-in JTAG and UART interface
RGB LED
Two buttons
JTAG connector
IO 48 pin 0.1" step connector
5V power supply jack
ON/OFF switch

[BerndJ]

"This is made by Espressif so may be available from china directly for less."

Sorry, it´s made from Olimex, and u did not can get it direct from China.

Take a look at his homepage, good products to fair prices, .... and make in europe.

But there´s a problem, it´s using the ESP32, NOT ESP8266....

..... and did u see any kind of software here regarding these part ???

I hope that some creative heads here find a way to use the ESP32 with the Plugins for the ESP8266 !!

Hope it helps.

best wishes

Bernd Jung

BTW: i had here two

https://www.olimex.com/Products/IoT/ESP ... e-hardware

waiting for the first release

[toffel969]

There is a thread on experimental section on esp32. It all depends on the state of the arduino ide, it wasn't very far last time I checked, maybe that changed though. Would be very exciting to see esp easy run on esp32

[Drum]

From the olimex site "The ESP32-WROVER-KIT product is simply ESP-WROVER-KIT. It is not designed nor manufactured by Olimex. This board is designed and manufactured by the ESP32 creators - "Espressif Systems". We are distinguished "Espressif Systems" reseller."

I thought someone had espeasy running on the Esp32.. will have to look and see if I can find that again