How to use NodeMCU with EasyESP for Digital Input Detection ?

[asking]

Hi,

I have successfully used EasyESP with Openhab using MQTT for Digital outputs (Turning off/on devices) works great..

But now i have requirement of Digital input detection. I have configured Boot State to input for GPIO 2 and GPIO14

I am confused, on defining boot state to input will enable pull up resistors for those physical pins ? so i just have to contact that pin to Ground pin to detect 0 or 1 ?

Because in pinstate buffer

Pin state table shows value/state 0 always.

Please help me how i can identify input state directly from easyesp interface ?