Let's Control It

Is a chance to run ESPEasy out of the box with this nodemcu "clone"
http://www.wemos.cc/wiki/doku.php?id=en:start

The website says it can be programmed with the ESP-Arduino IDE, so you can flash ESPEasy on it.

I have 2x Wemos D1 and 1x Wemos D1 Mini and also the end-of-life Wemos Lolin. All running fine .

Mine are on on toll aéroport, Christmas time, toll are long

Just read that those are compatible with nodemcu code since 03 Décembre 2015

Deennoo wrote:Mine are on on toll aéroport, Christmas time, toll are long

Just read that those are compatible with nodemcu code since 03 Décembre 2015

When you flash ESPEasy on this thing the NodeMCU firmware will be overwritten/erased so compatibility is not important I think.

ok thanks, wainting to get it !

As I use the Arduino environment (also the new 2.0 release on 1.6.5), I can confirm this works perfectly. Also it auto sets program mode, very easy . You just hit upload, no need to reset and pull up/down some GPIO's.

Recieve today 5 x Wemos D1 Mini + dht shield

After solding pin, and loading ESPEasy b 58 on It, that run fast ! and looks stable, lets see the futur.

On mini i had to put d3 to gnd to enter on uploading mode.

DHT11 or DHT22?

Over which GPIO Pin the DHT is connected? Can you post a screen from ur Device Config?

Thx

Hi, I can confirm D! by Wemos works fine, have latest version on and works pretty well, btw I have ordered few of these breadboards so if you need something for quick prototyping

http://www.aliexpress.com/item/Free-shi ... 19368.html