Page 1 of 1
Two BME280s on ESP8266 using ESP Easy
Posted: 17 Jun 2018, 01:15
by barneylejeune
What do I need to do to connect to BME280s to the same ESP8266 using ESP Easy? I want to monitor temperature, humidity and pressure both inside and outside and would like to do this by using two BME280s and a single ESP8266. Is this possible?
Re: Two BME280s on ESP8266 using ESP Easy
Posted: 17 Jun 2018, 05:10
by grovkillen
Re: Two BME280s on ESP8266 using ESP Easy
Posted: 13 Jul 2018, 00:38
by whatsupskip
I don't suppose you know who took the pictures of the plastic box/case used in these pictures?
Particularly where was it purchased from.
Re: Two BME280s on ESP8266 using ESP Easy
Posted: 13 Jul 2018, 10:14
by grovkillen
Re: Two BME280s on ESP8266 using ESP Easy
Posted: 13 Jul 2018, 11:54
by HomeJCL
@Grovkillen
Am I wrong or do these enclosures have a cable hole on top and bottom ?
Re: Two BME280s on ESP8266 using ESP Easy
Posted: 13 Jul 2018, 13:07
by grovkillen
Not a cable hole per say but yes, holes. The plastic plug in the middle is to fixate the PCB inside the enclosure, not included with the enclosure.
Re: Two BME280s on ESP8266 using ESP Easy
Posted: 13 Jul 2018, 23:12
by whatsupskip
Thank you.
I spent over an hour looking for similar cases on Aliexpress and couldn't find any as good value or suitable as this one.
