Is it possible to get IP address after boot (via serial monitor)?

[petrho]

Is there an easy way to get the ip address when it boot?

[kr0815]

Are you connected via Serial Interface ?
Just type "Settings" with capital S, then you´ll see the IP Address

[petrho]

Thanks - I didn't know that "trick". Is it more commands available?

[kr0815]

yes, look here at the end:

http://www.esp8266.nu/index.php/ESPEasy

[ManS-H]

Are you connected via Serial Interface ?
Just type "Settings" with capital S, then you´ll see the IP Address

Whats the difference between Settings and settings? I see the same result.

[spaceguard]

I connected via serial Interface. I wrote "Settings" command in terminal but nothing happened.

How does it work?

test.jpg (247.5 KiB) Viewed 7831 times

[chrille]

I connected via serial Interface. I wrote "Settings" command in terminal but nothing happened.

You need to make sure your terminal program sends both <CR> and <LF> ("DOS newline").
This has bitten me in the past, since minicom (which I use on Mac and Linux only sends unix style newlines)

- Jan

[spaceguard]

Thanks Jan !