Hello,
on my NodeMCU i use GPIO 0 (D3) connected to a door switch. If the door is closed GPIO 0 is connected to ground.
Everything works fine.... but in the case that GPIO 0 is connected to ground and the node reeboots (power failure...) it dosn´t start.
I first have to disconnect the contact from ground and reconnect the power that it boots again and i can use it.
Has anybody the same problem or can help me?
Regards
Andreas
Problems with Restarting while Gpio 0 is connected to Ground
Moderators: grovkillen, Stuntteam, TD-er
- grovkillen
- Core team member
- Posts: 3621
- Joined: 19 Jan 2017, 12:56
- Location: Hudiksvall, Sweden
- Contact:
Re: Problems with Restarting while Gpio 0 is connected to Ground
Please read here: https://www.letscontrolit.com/wiki/inde ... figuration
During boot GPIO 0 need to be HIGH (1).
During boot GPIO 0 need to be HIGH (1).
ESP Easy Flasher [flash tool and wifi setup at flash time]
ESP Easy Webdumper [easy screendumping of your units]
ESP Easy Netscan [find units]
Official shop: https://firstbyte.shop/
Sponsor ESP Easy, we need you
ESP Easy Webdumper [easy screendumping of your units]
ESP Easy Netscan [find units]
Official shop: https://firstbyte.shop/
Sponsor ESP Easy, we need you
Who is online
Users browsing this forum: No registered users and 125 guests