Hello,
I used EasyESP version 2.00 and connected a DHT22 to D4 (GPIO 2). Due to the reason that the sensor in the bedroom I would like to globally disable the blue LED. I already saw and forum entry saying that in order to disable the blue led I have to set D4 to low.
Unfortunately this is not possible because the DHT22 is connected to this port and unforunately this was the only port I found where I don't need a resistor.
Does anyone have an idea to how I could disable the blue blinking led.
BR Moria8
Disable blue LED
Moderators: grovkillen, Stuntteam, TD-er
- grovkillen
- Core team member
- Posts: 3621
- Joined: 19 Jan 2017, 12:56
- Location: Hudiksvall, Sweden
- Contact:
Re: Disable blue LED
Remove the diode?
ESP Easy Flasher [flash tool and wifi setup at flash time]
ESP Easy Webdumper [easy screendumping of your units]
ESP Easy Netscan [find units]
Official shop: https://firstbyte.shop/
Sponsor ESP Easy, we need you
ESP Easy Webdumper [easy screendumping of your units]
ESP Easy Netscan [find units]
Official shop: https://firstbyte.shop/
Sponsor ESP Easy, we need you
Re: Disable blue LED
i solved this with pliers blinking leds in a sleeping room are annoying...
Re: Disable blue LED
Keep things easy...
I'd just put a little piece of black duct tape on the led...
The led is usefull sometimes for diagnostics so i wouldn't want to remove it or otherwise "kill" it.
Usually the problem doesn't occur often with an ESP in a closed case.
Regards
Shardan
I'd just put a little piece of black duct tape on the led...
The led is usefull sometimes for diagnostics so i wouldn't want to remove it or otherwise "kill" it.
Usually the problem doesn't occur often with an ESP in a closed case.
Regards
Shardan
Regards
Shardan
Shardan
Who is online
Users browsing this forum: Bing [Bot] and 16 guests