ESPeasy has support for both the Wemos motor shield and the Adafruit motor shield. At the moment only the Adafruit shield is supported for stepper control and is using i2c communication, just like the Wemos shield. There has been some very good work done on development of stepper control using the Wemos motor shield here:
https://github.com/masutokw/WEMOS-MOTOR ... 2C-STEPPER
and looking at the fact that both are using i2c protocol, I was thinking if it would be possible to adapt the Adafruit plugin for controlling the stepper ability of the Wemos shield without a complete re-write of the plugin.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 16 guests