Let's Control It

Has something changed recently with the Switch plugin ???

I used to be able to send an event (from Node-RED vai MQTT) to trigger a rule that would toggle a GPIO pin.
So I could (remotely) check if the input was working.

I also used a Switch plugin to check the state of an input (on the same pin) (this was in fact an infra-red detector).

What happens now is... the switch input works fine UNTIL I do a remote test then it fails to work anymore until I reboot the Wemos.

Seems like the GPIO command is messing-up the input mechanism.

Any advice would be much appreciated.

Regards, David

Well, not "recently"
It looks like some changes made around Christmas last year.