Ser2Net - SWAP_PINS
Posted: 15 Jun 2020, 14:31
Tested the serial server. Works fine but I suspect the serial device I will connect to might be confused by all "debug data" like
1082872 : WD : Uptime 18 ConnectFailures 0 FreeMem 17152 WiFiStatus 3
1103387 : MQTT : Intentional reconnect
1104417 : MQTT : Failed to connect to broker
Tried it a similar function with pure Arduino, exapmle sketch "WiFiTelnetToSerial".
It had a "SWAP_PINS" option which set HW serial port to pins GPIO13 and 15. Std RX and TX was then set as SoftwareSerail ports.
By doing this, the serial monitor worked just as usual but the Ser2Net gateway was not affected by debug output.
Any chance to get this on the wish list?
1082872 : WD : Uptime 18 ConnectFailures 0 FreeMem 17152 WiFiStatus 3
1103387 : MQTT : Intentional reconnect
1104417 : MQTT : Failed to connect to broker
Tried it a similar function with pure Arduino, exapmle sketch "WiFiTelnetToSerial".
It had a "SWAP_PINS" option which set HW serial port to pins GPIO13 and 15. Std RX and TX was then set as SoftwareSerail ports.
By doing this, the serial monitor worked just as usual but the Ser2Net gateway was not affected by debug output.
Any chance to get this on the wish list?