Hello from Germany
Posted: 19 Jun 2020, 15:49
Hi there,
I am using ESPEasy since a few years for home automation. Thank you for the huge amount of work you invested and the great project this became.
I started working on a Python module that wraps a class around an ESPEasy device and creates HTTP requests to do some basic GPIO manipulation and sensor reading.
I needed to dig a little bit deeper into an issue with the current release and this is why I am here. The issue is already part of a current pull request though, so I will just read a little bit along.
I hope it is ok if I link to the ESPEasy project on a few points in my documentation.
Regards
I am using ESPEasy since a few years for home automation. Thank you for the huge amount of work you invested and the great project this became.
I started working on a Python module that wraps a class around an ESPEasy device and creates HTTP requests to do some basic GPIO manipulation and sensor reading.
I needed to dig a little bit deeper into an issue with the current release and this is why I am here. The issue is already part of a current pull request though, so I will just read a little bit along.
I hope it is ok if I link to the ESPEasy project on a few points in my documentation.
Regards