Quigg RCR/DS5.3711A

Information and news about RFLink development and releases

Moderators: Voyager, BertB, rtenklooster, Stuntteam

Post Reply
Message
Author
manjh
Normal user
Posts: 426
Joined: 08 Feb 2016, 11:22

Quigg RCR/DS5.3711A

#1 Post by manjh » 05 Mar 2017, 19:21

I just bought a set of Quigg switches at a German Aldi store, good deal: 4 switches plus RC for 14,99 Euro.
Tried to "learn" into Domoticz, it accepted the signal but then refused to send out a signal when I clicked the icon of the new on/off switch.

So I migrated my RFLink to the latest release 45, and now the signal from the RC is not recognized in Domoticz any more.

Is this a problem? Is this set not supported, and if so: any chance of adding it?

User avatar
Stuntteam
Site Beheer
Posts: 603
Joined: 27 Jan 2016, 16:46

Re: Quigg RCR/DS5.3711A

#2 Post by Stuntteam » 05 Mar 2017, 19:24

Hi,

it should be supported..
Make a debug log with R45 as described here: http://www.nemcon.nl/blog2/development
and mail that to me..
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8

manjh
Normal user
Posts: 426
Joined: 08 Feb 2016, 11:22

Re: Quigg RCR/DS5.3711A

#3 Post by manjh » 05 Mar 2017, 19:30

Apologies. After upgrading RFLink I failed to do a system restart... RFLink was not accessible for anything.
So I re-booted, and tested the Quigg units again: works just fine..... problem solved!

By the way: my compliments for the extremely quick responses to my post!

User avatar
Stuntteam
Site Beheer
Posts: 603
Joined: 27 Jan 2016, 16:46

Re: Quigg RCR/DS5.3711A

#4 Post by Stuntteam » 05 Mar 2017, 20:05

:)
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest