So, I decided to use the Delay command - see below. But this does not work - the code goes fast from event,L1 (another action with the instructions to switch on pump and the specific leg), to event,L4 - without executing any of L1,L2,L3 - and only executes L4.
I assume the Delay node cannot wait - how do I do it then? With timerSet ?
Code: Select all
On Clock#Time=All,%sunrise+15m% do
if [Vars#Auto]=1
event,L1
Delay,[Vars#durLegRest]
event,L2
Delay,[Vars#durLegRest]
event,L3
Delay,[Vars#durLegRest]
event,L4
Delay,[Vars#durLegRest]
endif
endon