I’m a new user of ESPeasy on a ESP8266
Mi goal is to publish MQTT messages from the esp to a mosquitto broker.
I have a working MQTT mosquitto broker. I tested it with MQTT lens.
In ESPeasy I also installed the controler.
Controller Settings
Protocol: Openhab MQTT
Locate Controller: Use IP address
Controller IP: 192.168.x.xxx
Controller Port: 1883
Minimum Send Interval: 100 [ms]
Max Queue Depth: 10
Max Retries: 10
Full Queue Action:Ignore new
Check Reply:ignore acknowlegdment
Client Timeout: 1000 [ms]
Controller User: openhab
Controller Password: •••••
Controller Subscribe: /%sysname%/#
Controller Publish: /%sysname%/%tskname%/%valname%
Controller lwl topic: muziek
LWT Connect Message:
LWT Disconnect Message:
When I use the command "publish muziek, test123" in the command line of the Tools-tab, all works fine.
I recieve the same message in the broker (i verified this with MQTT Lens)
When i add a DS18B20-sensor as a device, i’ts measuring the correct temperature. I also checked "send to controler"
But still there is no temperature published to the broker. (according to what i can see with MQTT Lens).
I have the same problem with the AM2320-sensor.
What am I doing wrong?