MQTT listen to a GPIO, but not name

[BlueMan]

I have a problem with switching a state for a relay (Przekaznik) with MQTT - I would like to use the name of device instead gpio. This will be the same way as espeasy broadcasting a message of changed state of a device.

To change a state, with this command:

Code: Select all

ESP_Gabinet/gpio/12 1

(or zero to turn it off) is working fine, but when I want to use

Code: Select all

ESP_Gabinet/Przekaznik/State 1

then nothing happens.

[grovkillen]

You should use the cmd topic. See here: https://espeasy.readthedocs.io/en/lates ... mmand.html