Hi,
I've just bought some Shelly 1 devices and installed the image ESP_Easy_mega_20200426_hard_Shelly_1_2M256.bin. Everything works wine except that there are almost no plugins available. Only four plugins/devices are listed:
Generic - Dummy Device
Generic - MQTT Import
Generic - System Info
Switch input - Switch
On my ordinary ESP8266 I have access to all plugins.
The plan was to put in some I2C devices with my Shelly to measure temperature etc.
Do I need to build a separate image to have the plugins or is it some other config that controls this?
Regards,
/Martin
No plugins with shelly firmware?
Moderators: grovkillen, Stuntteam, TD-er
- grovkillen
- Core team member
- Posts: 3621
- Joined: 19 Jan 2017, 12:56
- Location: Hudiksvall, Sweden
- Contact:
Re: No plugins with shelly firmware?
Yes the Shelly version is only built with the bare minimum of plugins to fit that board. So please compile your specific plugin list yourself.
ESP Easy Flasher [flash tool and wifi setup at flash time]
ESP Easy Webdumper [easy screendumping of your units]
ESP Easy Netscan [find units]
Official shop: https://firstbyte.shop/
Sponsor ESP Easy, we need you
ESP Easy Webdumper [easy screendumping of your units]
ESP Easy Netscan [find units]
Official shop: https://firstbyte.shop/
Sponsor ESP Easy, we need you
Re: No plugins with shelly firmware?
The the Shelly ones have more flash than most Sonoff or Blitzwolf units.
Those have 2M flash of which we have roughly 1.5 MB available for sketch + OTA and now with the support of .bin.gz updates we could add a lot more plugins to it.
For example the 'normal' set would fit I guess.
Those have 2M flash of which we have roughly 1.5 MB available for sketch + OTA and now with the support of .bin.gz updates we could add a lot more plugins to it.
For example the 'normal' set would fit I guess.
Who is online
Users browsing this forum: No registered users and 113 guests