Moderators: grovkillen, Stuntteam, TD-er
-
Cdzn
- Normal user
- Posts: 58
- Joined: 06 Oct 2020, 18:15
#1
Post
by Cdzn » 03 Nov 2021, 22:06
I decided to flash my SonOff T3EU2C and flashing it ESP8266.normal 1m. To configure it i should set touch button on GPIO-9 and write the rules switch GPIO-5 whenbutton is acctive. But i can`t see GPIO-9. Here is a screenshot.
-
Attachments
-
- 123.jpg (312.87 KiB) Viewed 8825 times
Last edited by
Cdzn on 03 Nov 2021, 22:25, edited 1 time in total.
-
TD-er
- Core team member
- Posts: 8794
- Joined: 01 Sep 2017, 22:13
- Location: the Netherlands
-
Contact:
#2
Post
by TD-er » 03 Nov 2021, 22:17
GPIO-9 is not available in an ESP8266. For that you need an ESP8285.
So please check if the unit really has an ESP8285 and then use that build for it.
-
Cdzn
- Normal user
- Posts: 58
- Joined: 06 Oct 2020, 18:15
#3
Post
by Cdzn » 03 Nov 2021, 22:26
TD-er wrote: ↑03 Nov 2021, 22:17
GPIO-9 is not available in an ESP8266. For that you need an ESP8285.
So please check if the unit really has an ESP8285 and then use that build for it.
Ok. Will try tomorrow. Thanks for advice
-
Cdzn
- Normal user
- Posts: 58
- Joined: 06 Oct 2020, 18:15
#4
Post
by Cdzn » 04 Nov 2021, 06:08
TD-er wrote: ↑03 Nov 2021, 22:17
GPIO-9 is not available in an ESP8266. For that you need an ESP8285.
So please check if the unit really has an ESP8285 and then use that build for it.
Yep. This is 8285.
- photo_2021-11-04_12-06-18.jpg (77.5 KiB) Viewed 8809 times
Thank You! Mb for someone it could be helpful.
Who is online
Users browsing this forum: No registered users and 1 guest