Hi
My setup : RPI 4B + RFLink Nodo 433.92 Firmware 48 + Jeedom 4.2.7
I read everywhere that Chacon RIO devices are supported, but this light switch seems to be unsupported.
It is not detected in inclusion mode.
Has someone tested ?
Thanks
JDenis
Chacon DIO Light Switch / Connect Rev-Light
Moderators: rtenklooster, Voyager, BertB, Stuntteam
-
- New user
- Posts: 1
- Joined: 03 Feb 2022, 09:50
Re: Chacon DIO Light Switch / Connect Rev-Light
Hi,
In general Chacon Dio is supported.
It is always possible that a new model is not supported or that there is something else (for example a low battery) that cuases an issue.
Make a debug log as described here:
https://www.rflink.nl/develop.php
and mail it to me (email address is on the page as well)
In general Chacon Dio is supported.
It is always possible that a new model is not supported or that there is something else (for example a low battery) that cuases an issue.
Make a debug log as described here:
https://www.rflink.nl/develop.php
and mail it to me (email address is on the page as well)
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Who is online
Users browsing this forum: No registered users and 2 guests