Because @bledat wants to change the variables in the rules editor as far as i understood... so that this change happens almost immediately there is a loopWhy do you need the 5 sec interval timer?
and since
Code: Select all
On Clock#Time=All,**:** Do
There is only one relay that hat a 15min toggle and that gets an extra rules timer....
... but somehow i remember that there is a new functionality...
could this:
Code: Select all
longpulse,2,1,900,900,-1
Code: Select all
On Rules#Timer=1 Do
If [Var#1]=2
GPIOToggle,14
Elseif [Var#1]=0
GPIO,14,1
Endif