RFLink RF Module defect?

Moderators: rtenklooster, Voyager, BertB, Stuntteam

Post Reply
Message
Author
lecolit
New user
Posts: 2
Joined: 30 May 2023, 23:16

RFLink RF Module defect?

#1 Post by lecolit » 30 May 2023, 23:22

Hello,

I used the RFLink 433.92Mhz for few years now, but it suddenly stopped working.
Did a reset, flashed the firmware again, reset eeprom etc.

20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R48;
10;version;
20;01;VER=1.1;REV=48;BUILD=04;
10;status;
20;02;STATUS;setRF433=ON;setNodoNRF=OFF;setMilight=OFF;setLivingColors=OFF;setAnsluta=OFF;setGPIO=OFF;setBLE=OFF;setMysensors=OFF;
10;rfdebug=on;
20;03;RFDEBUG=ON;
10;rfudebug=on;
20;04;RFUDEBUG=ON;
10;PING;
20;05;PONG;


The problem is when sending a KAKU command from my remote nothing shows up in the log.

But the PING reacts with a PONG. Not clear to me if the PING is actual sending something out through RF and receiving it (PONG).

Could this mean the RF Unit has died?

User avatar
Stuntteam
Site Beheer
Posts: 791
Joined: 27 Jan 2016, 16:46

Re: RFLink RF Module defect?

#2 Post by Stuntteam » 31 May 2023, 08:47

The ping/pong part is used by controlling software (domoticz/HA) to check if the RFLink is still alive.
It does not say anything about the RF module itself.
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8

lecolit
New user
Posts: 2
Joined: 30 May 2023, 23:16

Re: RFLink RF Module defect?

#3 Post by lecolit » 02 Jun 2023, 17:33

I replaced the RFLink part and it's working again!

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests