I would like to have a virtual sensor in Domoticz that shows only information about temperature and humidity, based on data from the BME860.
For this purpose, I have created a virtual temperature and humidity senator idx=143 and I enter the ESP data into it with the command:
Code: Select all
SendToHTTP 192.168.0.25,8080,/json.htm?type=command¶m=udevice&idx=143&nvalue=0&svalue=[BME680#Temperature];[BME680#Humidity]
Code: Select all
THGN122/123/132,
THGR122/228/238/268
Code: Select all
0,
12.15 C, 72.16%
The debug in ESP shows that measurements are passed correctly, without any leading "0" or so.
However, the sensor indications on the list in the dashboard are empty. Not zero, but just no values are displayed.
How can I correctly display the temperature and humidity data, as is the case with sensors such as DTH22?