Page 1 of 1
[Feature Request] Support for mh-z16 CO2
Posted: 14 Sep 2017, 20:52
by Evolver_sweden
Hi..
I need the support for mh-z16 Co2
Here is the documentation..
It can operate in both UART or I2C mode, i think i wan't it in I2C mode.. (it's a tiny switch to switch between the modes on the MH-Z16 Module)
http://sandboxelectronics.com/wp-conten ... eet_EN.pdf
http://sandboxelectronics.com/?p=1126
Re: [Feature Request] Support for mh-z16 CO2
Posted: 15 Sep 2017, 16:23
by toffel969
Well... then why don't you give writing a plug-in a go. " I think I want it in I2C..." sounds like the very wrong way to approach the devs.
Re: [Feature Request] Support for mh-z16 CO2
Posted: 16 Sep 2017, 20:00
by LisaM
toffel969 wrote: ↑15 Sep 2017, 16:23
Well... then why don't you give writing a plug-in a go. " I think I want it in I2C..." sounds like the very wrong way to approach the devs.
+1
I think i want Evolver_sweden to build it...
Re: [Feature Request] Support for mh-z16 CO2
Posted: 16 Sep 2017, 21:14
by grovkillen
LisaM wrote: ↑16 Sep 2017, 20:00
toffel969 wrote: ↑15 Sep 2017, 16:23
Well... then why don't you give writing a plug-in a go. " I think I want it in I2C..." sounds like the very wrong way to approach the devs.
+1
I think i want Evolver_sweden to build it...
Yes, that request didn't come out right.
Re: [Feature Request] Support for mh-z16 CO2
Posted: 18 Sep 2017, 12:48
by TD-er
At a first glance at the datasheet, the protocol looks a lot like the MH-Z19.
Support for that sensor is already present.
It is quite an expensive sensor. What makes it better than the (much smaller) S8 or MH-Z19 sensors?