Worcester Bosch DT10RF Thermostat and RFLink
Posted: 24 Feb 2019, 09:28
Hi, I have just started to use RFLink, as I have a Worcester Bosch DT10RF Thermostat and wanted to control it using RFLink. I have it all setup as per the instructions using:
Arduino MEGA
RXB6
Firmware r48
Using the RFLinkLoader, I can see and receive other RF devices, ie, Motion Sensors and Window/Door sensors, so I know the setup is working, but when I activate the Worcester Bosch DT10RF Thermostat, I see nothing in RFLinkLoader. Is there something I need to do to see the RF codes?
Kind regards
Arduino MEGA
RXB6
Firmware r48
Using the RFLinkLoader, I can see and receive other RF devices, ie, Motion Sensors and Window/Door sensors, so I know the setup is working, but when I activate the Worcester Bosch DT10RF Thermostat, I see nothing in RFLinkLoader. Is there something I need to do to see the RF codes?
Kind regards