Page 1 of 1
Buzzer tone off
Posted: 12 May 2021, 17:11
by xxx_turbo_xxx
I just made e rule whch plaes a sound via RTTTL on a buzzer board. My proble is tht after finishing the sound the buzzer plays an endless tone instead of being quiet. How can I programm the rule to do so?
Thanks for your help in advance!
Re: Buzzer tone off
Posted: 12 May 2021, 17:31
by TD-er
Can you show your current rules?
Re: Buzzer tone off
Posted: 12 May 2021, 18:47
by xxx_turbo_xxx
Sure... This was a try. But after playing the melody there is a continious beep.
When I put the GPIO,16,1 in the en at least the sound stops but in between the melody all the brakes in between are with tone instead of silence.
On System#Boot do
rtttl,16:d=4,o=5,b=112:8a,8a,a,8a,8a,a,8a,8c6,8f.,16g,2a,8a-,8a-,8a-.,16a-,8a-,8a,8a.,16a,8a,8g,8g,8a,g,c6,P
GPIO,16,1
endon
Re: Buzzer tone off
Posted: 12 May 2021, 20:11
by TD-er
And what if you set the gpio to "2" ?
See here for the "GPIO" command:
https://espeasy.readthedocs.io/en/lates ... #p000-page