Too dumb - switch input

[karl222]

Hi guys,

seems that I fail with one of the simplest tasks. I'd like to connect 2 push buttons on different gpio's 12 and 13.

I am using settings as shown in attachment.

When I wire ground to gpio 12, nothing happens in status of gpio, same with gpio 13.

What do I do wrong with such a simple task? I have tried it with three different wemos modules already, though it is no damaged device.

help appreciated - thx
karl

SwitchPict.jpg (96.1 KiB) Viewed 6177 times

[Ath]

What does not work as expected?

NB: You seem to have the Interval set to 0 seconds (= disabled), so the status won't be read and the devices page won't be automatically updated after that interval.

[karl222]

Seems this is the solution...

it is confusing, that this parameter is "optional"...

many thanks
karl

[Ath]

That was changed for those that don't want to repeatedly send out the state to the controllers, but still explicitly allow that by using the TaskRun command from rules.