http: C001 cnnection failed

[ewaldharmsen]

I have added domoticz as a controller.
I always get this error:

http: C001 cnnection failed

and the device does not get updated in domoticz.
I also tried the generic http controller with this Controller Publish command:

Code: Select all

/json.htm?param=udevice&type=command&idx=%id%&nvalue=0&svalue=%value%

That does not work either:

EVENT: http#192.168.1.200=404

In both cases I am sure the ip and port is ok.

SendToHTTP does work:

Code: Select all

on DS18b20#Temperature do
 SendToHTTP, 192.168.1.200,8080,/json.htm?param=udevice&type=command&idx=61&nvalue=0&svalue=[DS18b20#Temperature]
 endon

What goes wrong?

I run 20230306 - Mega on a Sonoff Dual R2

[Ath]

The 404 error suggests that the Domoticz server isn't reachable from where your ESP is, are you using the ip-address or a hostname for that server?
And please also enable HTTP support on Domoticz, next to HTTPS, and configure that HTTP port (usually 8080) on ESPEasy as we don't support the HTTPS protocol (yet).

As an alternative, you could install a MQTT server (usually Mosquitto is used on the same RPi that Domoticz is running on), and use the Domoticz MQTT controller instead.

[ewaldharmsen]

Well I do have http enable as sendHTTP is working…

[Ath]

Can you share the configuration page of the Domoticz HTTP controller? (unmasked screenshot, attached to this thread, please)

[ewaldharmsen]

see the screenshot here:

https://1drv.ms/i/s!AmTy_UOLELH8ketl_nMMdvfGeWDtUw

[Ath]

Can you please attach the screenshot in the forum? External services tend to 'lose' those images after a while, and throw adds at you when trying to view the image.

[ewaldharmsen]

Can you please attach the screenshot in the forum? External services tend to 'lose' those images after a while, and throw adds at you when trying to view the image.

I don’t know how to do that

[Ath]

I don’t know how to do that

There is an Attachments tab, below the Post a Reply edit box:

Screenshot - 3-05-2023 , 10_08_16.png (12.85 KiB) Viewed 1391 times

[ewaldharmsen]

Flashed it with todays latest version and it works now

[Ath]

Flashed it with todays latest version and it works now

Great, but I'm still interested what actually caused the issue, might you find that.