The binary code I can send with the Arduino Uno using the RCSwitch library is 010101010111010001. To make it work, I have to set the protocol of the RCSwitch to 12.
I now want to automate the process with RFLink connected to Home Assistant on a Raspberry Pi. Unfortunately, RFLink doesn't seem to recognize the signal from the Arduino. It's either detected as one of these devices/commands:
But they all don't work. Here is the debug log:20;21;LEGRANDCAD;ID=2ae8;SWITCH=01;CMD=OFF;
20;0E;Bosch;ID=2aba;SWITCH=2;CMD=OFF;
20;17;Aster;ID=0a2c;SWITCH=02;CMD=ON;
Any ideas what I can do to make this work?20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R48;
10;version;
20;01;VER=1.1;REV=48;BUILD=04;
10;status;
20;02;STATUS;setRF433=ON;setNodoNRF=OFF;setMilight=OFF;setLivingColors=OFF;setAnsluta=OFF;setGPIO=OFF;setBLE=OFF;setMysensors=OFF;
10;rfdebug=on;
20;03;RFDEBUG=ON;
20;04;DEBUG;Pulses=36;Pulses(uSec)=630,570,240,240,570,540,240,240,570,540,240,240,570,540,240,240,540,540,240,540,240,570,240,240,540,570,240,240,540,240,540,240,540,570,210,6990;
20;05;LEGRANDCAD;ID=2ae8;SWITCH=01;CMD=OFF;